{"id":3263,"date":"2014-04-23T04:07:48","date_gmt":"2014-04-23T08:07:48","guid":{"rendered":"http:\/\/pages.vassar.edu\/magnes\/?p=3263"},"modified":"2014-04-30T03:41:20","modified_gmt":"2014-04-30T07:41:20","slug":"preliminary-data-magnetic-field-modeling","status":"publish","type":"post","link":"https:\/\/pages.vassar.edu\/magnes\/2014\/04\/23\/preliminary-data-magnetic-field-modeling\/","title":{"rendered":"Preliminary Data: Magnetic Field Modeling"},"content":{"rendered":"

In this post I will describing the specific charge distributions that I will be modeling and showing a brief derivation for the formulas I calculated<\/span>.<\/span><\/p>\n

Cylinder<\/span>:<\/span><\/p>\n

Problem 5.14 of Griffiths’\u00a0Introduction to Electrodynamics<\/em>\u00a04th edition\u00a0describes a long cylindrical wire of radius a<\/em>\u00a0and steady uniform flowing current\u00a0I<\/em>\u00a0over the outside surface of the cylinder.\u00a0<\/em>The magnetic field outside of the wire can be easily found by using Ampere’s Law.<\/p>\n

  <\/span>   <\/span>\"\[<\/p>\n

(1) <\/span>   <\/span>\"\begin{equation*}<\/p>\n

When looking at points inside of the cylinder, or \"s<a\", \"I_{enc}=0\" and so we know that:<\/p>\n

(2) <\/span>   <\/span>\"\begin{equation*}<\/p>\n

Combining our two cases in (1) and (2) we have:<\/p>\n

(3) <\/span>   <\/span>\"\begin{equation*}<\/p>\n

This is plotted below using Mathematica.<\/p>\n

\"Cylinder\"<\/p>\n

As expected, the magnetic field follows the commonly known right-hand-rule where the direction of the current curls around the direction of current.<\/p>\n

Plane -> Slab :<\/span><\/p>\n

Problem 5.15 of Griffiths’\u00a0Introduction to Electrodynamics<\/em>\u00a04th edition, a thick infinite slab extending from z=-a to z=a carries a uniform volume current \"\mathbf{J}=J\widehat x\". The magnetic field inside of the slab can found using Ampere’s Law again.<\/p>\n

  <\/span>   <\/span>\"\[<\/p>\n

(4) <\/span>   <\/span>\"\begin{equation*}<\/p>\n

When looking at point outside of the slab, our \"I_{enc}=\mu_{0}IaJ\", and so,<\/p>\n

(5) <\/span>   <\/span>\"\begin{equation*}<\/p>\n

Sphere -> Ring<\/span>:<\/p>\n

After some research and individual work, I have come to realize that the magnetic field of either rotating conducting sphere or a spherical solenoid is very complicated. I decided to simplify the distribution to two dimensions rather than three for now. A sphere can be viewed as a collection of disks or rings, so I derived the formula for the magnetic field of a ring with radius R and steady current\u00a0I\u00a0<\/em>.<\/p>\n

By setting our coordinate system at the center of the ring, we know that the horizontal components of the magnetic field will cancel out through symmetry and the principle of superposition,\u00a0and we are left with only the vertical component. This leaves us with:<\/p>\n

  <\/span>   <\/span>\"\[<\/p>\n

where \"\theta\" is defined as the angle between the wire and our position vector \"\mathbf{r}\". It follows then that<\/p>\n

(6) <\/span>   <\/span>\"\begin{equation*}<\/p>\n

 <\/p>\n

References:<\/p>\n